altium designer 19 constantly crashing on pcb

The size of the dialog upon closing will be maintained when the same dialog is reopened. Routing with conflict resolution on 'Push Obstacles' caused the software to crash.ĭRC HTML reports were blank when projects were stored on the driver/folder with write protection. The 'Obey Polygon Cutout' option has been added to the Polygon Pour properties. Polygon pour speed was improved for complex boards with a big number of pads or vias. Hatched polygon pour did not obey polygon cutouts near obstacles, which caused violations to occur. Pads that were set to 'rectangular' and contained a hole size equal to its length were not displayed in the Drill Table.ĭiscontinuity occurred in generated STEP files if a bending angle contained a negative value. Unnecessary controls were selected when using the Tab keyboard shortcut in some object properties panels ( BC:11281) No Net split planes were not detected in the Unrouted Net rule. ( BC:15556)Ī crash occurred after loading a stackup, saving the Layer Stack Manager, then returning to the PCB document. The rotation column did not respect the comma and period separator change in the Pick and Place Setup dialog. ( BC:15365)Įrror appeared when exporting a Parasolid file when the 'Export All Copper' option was enabled. Values of alternate part parameters were missing for a design variant that is not selected. Traces did not automatically change their width until a trace was placed in the flex region. Wire names were not displayed in the tooltip in free documents. ( BC:12819)Ĭhanged the direction when adding additional ports and pins. The Physical checkbox in the Component Designator dialog will maintain its enabled or disabled state until the software is closed. Wires disappeared when dragging before using the Edit > Refactor command. Superscripts located in multi-channels displayed the previous designator rather than the logical designator. The page scaling in the Print dialog was displayed incorrectly. ( BC:16785)Ĭustom locations of cross reference parameters are reset to defaults after saving and reloading the schematic document. The Edit > Refactor > Move Selected Subcircuit to Different Sheet command changes the Unique IDs of the parts.

When the revision of the managed sheet is replaced, the Annotation file becomes invalid.

WMF and GIF graphics were not printed to PDF by Smart PDF and other tools. ( BC:17255)Īn error occurred when running the Smart PDF wizard for a free document. The Smart PDF output did not include embedded graphics. Some bitmaps were truncated in the generated PDF document. Build: 22 Date: 22 November 2021 Schematic 38985

Altium designer 19 constantly crashing on pcb